Small distribution board IP65 with 0.03A/16A RCBO for protecting 220V systems in recreational vehicles

Protection solution for all types of single-phase AC circuits in modern systems. The devices offer the following protection simultaneously: short-circuit protection, overload protection, additional protection or fault protection for protective measures against electric shock, preventive fire protection.

The circuit breakers are safely housed in the IP65 small distribution board made of impact-resistant plastic according to DIN 43871/VDE 0603.

Includes PE/N terminal, double membrane grommets, cover strips, labeling strips. Small distribution board, 3 module units, PE/N terminal, each with 1 clamping point 16 mm², 3 clamping points 6 mm², 3 elastic entries at the top, cover and labeling strips, insulating plugs, additional double membrane grommets.

Attention: Why are there two different variants here? DIN/VDE prescribes an all-pole disconnection in case of a fault for campers, which both variants shown here do. The important difference, however, is the miniature circuit breaker (MCB). In the 1P+N variant, this is located exclusively on phase L1. In the 2P variant, however, an overload can also be detected on N, which unfortunately makes this variant much more expensive. The background is as follows: In the camping sector, reverse-polarity protected CEE connections are prescribed (plug device according to IEC 60309), which theoretically makes it impossible to swap phase (L1) and neutral conductor (N). If this assignment is guaranteed, variant 1P+N also works without problems. However, if it cannot be ensured that L1 and N are not swapped, for example because adapters from CEE to Schuko (not permitted!) could be used, then variant 2P must be installed.

Installation should always be carried out by trained personnel. If you are unsure, please contact us. We would be happy to install the circuit breakers in your vehicle, including testing.